Toyota Celica DIY

Front bumper must be removed in installation of fog, horn, HID, some ground wirings, and CCD camera setup. 10mm deep socket wrench is useful for procedure.

Open the hood, and remove the plastic engine cover. Cover was fixed by plastic clips removable by pulling the center part.

right side.
Pull up the tire housing and remove 10mm HEX screw.

Remove blinker sockets by rotating from lens.

Four 10mm bolts and center clip be removed.

right left
Six 10mm HEX screw be removed.

Remove four 10mm nuts under the floor.

Pull down the bumper and remove from fender.

Pull forward, and bumper will be removed.